X Series E83 X3 2.0d (N47) OFFRD
34 33 051
Removing and installing or replacing non-
return valve for brake booster
Necessary preliminary tasks:
•
Read and comply with General Information.
•
Remove heater bulkhead.
Important!
-
If a rubber vacuum hose is fitted, it can be replaced
individually.
-
If a plastic vacuum line is fitted, it can only be replaced
as a single unit together with the non-return valve.
Note:
Before beginning work, fully press the brake pedal several times to
reduce the vacuum pressure in the brake booster. This makes it
easier to remove the non-return valve.
Pull off seal (1).
Remove non-return valve (2) from brake booster.
Installation:
Check sealing ring in brake booster and replace if necessary.
Unlock quick-release fastener (1) and detach vacuum line (2).
RA Removing and installing or replacing non-return valve for brake booster
BMW AG - TIS
06.02.2013 02:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
