X Series E83 X3 2.0d (N47) OFFRD
34 35 001
Replacing a brake pad sensor (front)
Important!
If a brake pad sensor that has already been ground has to be
replaced even though the minimum brake pad thickness has
not yet been reached, you must observe the following: The
new sliding contact must be filed down with a file to the same
length as the ground sliding contact.
Necessary preliminary tasks:
•
Remove wheel
Open plug housing (1).
Unclip lead of brake pad sensor (2) from plug housing (1).
Disconnect associated plug connection of lead from brake pad
sensor (2).
Expose lead for brake pad sensor up to brake pad.
Press clip (1) together and detach brake pad sensor (2) in
direction of arrow from brake pad (3).
Installation:
Make sure clip (1) and brake pad sensor (2) are correctly seated
in brake pad (3).
RA Replacing a brake pad sensor (front)
BMW AG - TIS
06.02.2013 02:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -