X Series E83 X3 2.0d (N47) OFFRD
34 52 525
Replacing one front pulse generator
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Read and comply with General Information.
Open plug housing (1), pull plug connection (2) out of fixture
and disconnect.
Pull cable with rubber grommet out of fixture on spring strut and
on body.
Installation:
Ensure proper locking of plug connector and proper seating of
rubber grommets.
Release socket head cap screw (1).
Withdraw pulse generator (2) from bore.
Installation:
Tightening torque 34 51 6AZ
.
Clean bore hole for pulse generator and grease with Staburags
NBU 12/K lubricating grease (refer to BMW Service Operating
Fluids).
RA Replacing one front pulse generator
BMW AG - TIS
06.02.2013 02:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -