X Series E83 X3 2.0d (N47) OFFRD
Release screws (1 and 2).
Release screws or rivets (1 to 3) on wheel arch trim (4).
Lever out wheel arch trim (4) at side.
Installation:
Make sure wheel arch trim (4) is in correct position.
Release screw (1) on bumper trim (2).
Important!
Do not damage bumper trim when pulling off.
Lever out bumper trim (1) with special tool 00 9 317 in direction
of arrow.
Pull bumper trim (1) forwards a little.
If necessary, disconnect plug connections on ultrasonic sensors
and/or front fog lamps.
Remove bumper trim (1) towards front with aid of a 2nd person.
RA Removing and installing/replacing front bumper trim (M Technic aerodynamic kit)
BMW AG - TIS
06.02.2013 03:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -