X Series E83 X3 2.0d (N47) OFFRD
51 71 200
Removing and installing / replacing seal on
rear door, left or right
Note:
Follow repair instructions for bonded seals.
Detach seal (1) from rear door (2).
Clean adhesive area.
Installation:
-
Pull protective film (liner) off seal to half-way point
-
Feed seal at top into rubber guide (3)
-
Gently press seal without stretching
-
Check positioning of seal, correct if necessary and firmly
press.
-
Pull remaining protective film (liner) off seal.
-
Press remaining seal without stretching.
-
Check positioning of seal, correct if necessary and firmly
press.
Important!
-
Do not grip bonding surface.
-
It is not the length of pressing in time but rather the level
of pressing (approx. 10 ... 15 N/cm
2
) which is decisive
here.
-
Separation of seal after pressing destroys the adhesive
layer.
Note:
After being pressed on gently, seal can be pulled off again up to 3
times. Do not dirty adhesive area.
RA Removing and installing / replacing seal on rear door, left or right
BMW AG - TIS
06.02.2013 05:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -