X Series E83 X3 2.0d (N47) OFFRD
65 50 011
Removing and installing (replacing) video
module for on-board monitor
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Remove flap in luggage compartment panel on left.
Unlock plug connections (1) and disconnect.
Installation:
Do not mix up antenna connectors (2).
Mark antenna plugs (2) and disconnect.
Release screws (3).
Release nut on stud (4).
Guide video module for on-board monitor (5) with holder over
stud (4) and feed out in direction of arrow.
Release screw (1).
Unclip wiring harness (2) at point (3) and pull video module for
on-board monitor (4) with holder (5) out of side recess slightly.
Feed video module for on-board monitor (4) in direction of arrow
out of holder (5) and remove.
RA Removing and installing (replacing) video module for on-board monitor
BMW AG - TIS
06.02.2013 11:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -