X Series E83 X3 3.0d (M57TU) OFFRD
12 90 ...
Removing and installing/replacing electronics
box
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Note:
Follow instructions for removing and installing electronic control
units
Necessary preliminary tasks:
•
Read fault memory.
•
Disconnect negative battery cable
•
Remove control unit; for more information, refer to Replacing
control unit
•
Disconnect vehicle wiring harness in engine compartment on
left.
Unlock DME control unit and remove.
If fitted, disconnect plug-in contact for electronics box fan.
Unlock equipment carrier at holder and remove.
Cut open cable tie (1). Release screws.
Remove rear plate.
RA Removing and installing/replacing electronics box
BMW AG - TIS
14.02.2013 22:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
