X Series E83 X3 3.0Sd (M57T2) OFFRD
31 12 050
Removing and installing/replacing left or right
tension strut
Important!
With build date 12/2006 the tension strut to guide joint
connection was increased by 10 mm. The upshot of this is
that on vehicles up to 12/2006 the guide joint must also be
replaced.
Mixed fitting of tension struts is permitted!
Necessary preliminary tasks:
•
Remove front assembly underside protection
•
If necessary, remove steering gear cover.
•
Detach front wheel arch trim
•
Remove guide joint
Release screw (1).
Release nut on rear side.
Swivel holder (2) for engine shielding at front towards centre of
vehicle and remove towards bottom.
Unfasten nut.
Remove screw towards front.
Remove tension strut.
Installation:
Replace self-locking nut.
Tighten bolt connection in normal position.
Tightening torque 31 12 1AZ
.
RA Removing and installing/replacing left or right tension strut
BMW AG - TIS
19.02.2013 20:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -