X Series E83 X3 3.0Sd (M57T2) OFFRD
32 41 060
Removing and installing/replacing vane pump
for power steering (M47T2, M57TU, M57T2)
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove belt pulley
•
Remove grounding cable from vane pump
Important!
Cover alternator with a suitable covering to prevent ingress of
hydraulic fluid.
Release banjo bolt and detach pressure line from vane pump.
Installation:
Replace sealing ring.
Make sure pressure line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 3AZ
.
RA Removing and installing/replacing vane pump for power steering (M47T2, M57TU, M5
BMW AG - TIS
19.02.2013 21:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
