X Series E83 X3 3.0Sd (M57T2) OFFRD
Open weld joints in area (1).
Installation:
Weld new component in area (2) additionally.
Open weld joints in area (1).
Installation:
Weld new component in areas (2) additionally.
Mark severance cut in accordance with measurement a and cut
rear axle carrier upper section (1) on both sides of vehicle.
Measurement a=220 mm from edge of square hole.
Installation:
Weld in reinforcement plates at severance cuts.
Open weld joints in areas (1) on both sides of vehicle.
Installation:
Weld new component in areas (2) additionally.
RA Replacing complete rear luggage compartment floor (tail panel removed)
BMW AG - TIS
20.02.2013 00:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -