Z Series E52 Z8 (S62) ROADST
Cylinder bank 1 to 4 (inlet side):
Remove slackened bolts. Take off spacer ring (1).
Cylinder bank 1 to 4 (inlet side):
Note:
The spline hub (1) accommodates a plate spring and a
supporting ring.
Take care: the supporting ring can easily fall out when removed.
Remove spline hub (1) with plate spring and supporting ring.
Cylinder bank 1 to 4 (inlet side):
Detach inlet chain wheel (3) from centering sleeve.
Keep inlet chain wheel (3) and chain tensioned.
Feed out inlet chain wheel (3).
Secure chain against slipping down.
Note:
To release cylinder head bolts: Use special tool 11 2 250 .
At narrow points, use a socket with 3/8" drive and a short
extension.
Release cylinder head bolts in sequence 10 to 1.
Lift off cylinder head.
RA Removing and installing right cylinder head (S62)
BMW AG - TIS
06.02.2013 22:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -