Z Series E85 Z4 2.5i (N52) ROADST
Note:
Schematic depiction of special tool 11 4 461 at lower bearing
bank (1) and upper bearing bank (2).
Important!
Tighten screw (3) on thrust piece to 2 Nm.
Position special tool 11 4 461 over screw connection of bearing
banks.
Make sure that legs come into exact contact on ground surfaces,
lower bearing bank (1) and upper bearing bank (2).
Initially tighten screw of special tool 11 4 461 to ground surfaces
of lower bearing bank (1) and upper bearing bank (2).
Important!
Tighten screws on thrust piece to 2 Nm.
Important!
Set special tool
11 4 350
to 2 Nm.
Pretension all special tools 11 4 461 with special tool
11 4 350 only.
RA Removing and installing / replacing exhaust camshaft (N52)
BMW AG - TIS
12.02.2013 03:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -