Z Series E85 Z4 2.5i (N52) ROADST
Crank engine at vibration damper in direction of rotation until
screw (1) is visible in opening.
Release all screws of torque converter with special tool
24 1 110 .
Crank engine further and release remaining 5 bolts.
Tightening torque 24 40 1AZ
.
Unfasten screws.
Installation:
Observe screw fastening sequence without fail.
Tightening torque, steel screws 24 00 1AZ
.
Aluminium screws must be replaced.
Tightening torque and angle of rotation
Aluminium screws 24 00 2AZ
.
Installation:
Secure angle of rotation special tool 00 9 120 with magnet
00 9 130 to floor plate.
Screw down aluminium screws according to angle of rotation.
Angle of rotation 24 00 2AZ
.
Installation:
Bore (1) in driving disk must be accessible from opening on
engine oil pan.
RA Removing and installing automatic transmission (6HP19Z/N52)
BMW AG - TIS
12.02.2013 05:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
