Z Series E85 Z4 2.5i (N52) ROADST
33 52 000
Removing and installing / replacing rear left
or right shock absorber
Note:
Read and comply with Information on replacing shock absorbers.
Necessary preliminary tasks:
•
Remove rear wheel
•
E85: Remove mounting for convertible top compartment floor
•
E86: Remove luggage compartment wheel arch trim
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
Support trailing arm with a workshop jack (1).
Release screw.
Installation:
Thrust washer (2) on rubber bearing must point to screw head.
Tighten bolt in normal position.
Tightening torque, 33 52 1AZ
.
Unscrew nuts.
Remove shock absorber with support bearing towards bottom.
Installation:
Replace sealing washer (between support bearing and body).
Replace self-locking nuts.
Tightening torque 33 52 3AZ
.
RA Removing and installing / replacing rear left or right shock absorber
BMW AG - TIS
12.02.2013 07:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -