Z Series E85 Z4 2.5i (N52) ROADST
51 12 050
Removing and installing / replacing carrier for
rear bumper trim
Necessary preliminary tasks:
•
Remove rear bumper trim
•
Remove trim on tail panel
If necessary, unclip aerial (1) in area (2).
Release nuts (1) on left/right and remove carrier straight towards
rear.
Tightening torque 51 12 3AZ
.
RA Removing and installing / replacing carrier for rear bumper trim
BMW AG - TIS
12.02.2013 09:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -