Z Series E85 Z4 3.0i (M54) ROADST
Release oxygen monitor sensor from above with special tool
11 7 020 .
Installation:
The threads of new oxygen monitor sensors are already
coated with Never Seez compound.
If an oxygen monitor sensor is reused, only apply a thin and
uniform coat of Never Seez compound (refer
to BMW Parts Service) to thread.
Oxygen monitor sensor section projecting into exhaust system
branch must not be cleaned or come into contact with
lubricant.
Cover oxygen monitor sensor when applying underseal.
Tightening torque 11 78 1AZ
.
Installation:
Check stored fault messages.
Now clear the fault memory.
RA Replacing oxygen monitor sensor (cylinders 1-3)
BMW AG - TIS
15.02.2013 12:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
