Z Series E85 Z4 3.0i (M54) ROADST
35 21 000
Removing and installing/replacing brake
pedal
Necessary preliminary tasks:
•
Remove trim panel for pedal assembly.
•
Remove brake light switch
Remove clips (1).
Installation:
Replace retainers (1).
Installation:
Use new retainer.
The retainer must be seated with both legs in the pin groove.
The workshop supervisor must mark the retainer with a dot of red
paint (1) thereby acknowledging correct installation.
Disconnect return spring.
Pull bearing bushing (1) out of brake pedal and press to left.
Twist brake pedal (2) downwards out of mounting in direction of
arrow.
RA Removing and installing/replacing brake pedal
BMW AG - TIS
15.02.2013 23:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -