Z Series E85 Z4 3.0i (M54) ROADST
37 14 512
Replacing rear ride-height sensor
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Disconnect plug connection (1).
Release nut (4) and disengage jointed rod with lever extension
from sensor lever (3).
Tightening torque 37 14 7AZ
.
Release screws (2) and remove ride-height sensor.
Installation:
Sensor lever (3) must from ride-height sensor in direction of
travel.
Tightening torque 37 14 6AZ
.
After installation:
•
Check headlight adjustment, correct if necessary
RA Replacing rear ride-height sensor
BMW AG - TIS
15.02.2013 23:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -