Z Series E86 Z4 3.0Si (N52) COUPE
Adjusting retraction depth:
Open door and door window glass.
Lever out rubber plugs (1 and 2).
Adjust height via adjusting screw (3) at front and rear.
Check adjustment, repeat procedure if necessary.
After adjustment at A-pillar rail:
To avoid distortion in the system, release screw (1) by a half turn
in clockwise direction and tighten down again.
Tightening torque 51 32 2AZ
.
Note:
Door window glass (2) and clamping plate (3) must not be
displaced here.
Ideal adjustment, pretension:
Close door until lock closes in first catch.
In this door position, top edge of door window glass (1) must rest
on door seal (2).
Adjusting pretension:
Note:
Adjustment can be carried out by way of opening for outside door
handle or window guide rail.
First carry out adjustment via window guide rail.
If ideal adjustment is not yet obtained, proceed with adjustment by
way of outside door handle opening.
RA Adjusting left or right front door window glass
BMW AG - TIS
08.02.2013 14:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -