Z Series E86 Z4 3.0Si (N52) COUPE
51 47 000
Removing and installing/replacing front
(inside) left or right entrance cover strip
Disengage retaining lugs (5) of entrance cover strip (2) from
both adjoining panels.
Important!
Carefully lever out entrance cover strip (2).
Lever out entrance cover strip (2) at front retaining points (3).
Pull back entrance cover strip (2) and feed out of rear retaining
points (1).
Installation:
Position entrance cover strip (2) preinstalled with clips (4) on
associated bores and clip into place.
Installation:
Clip mountings of entrance cover strip (2) must not be damaged.
Retaining lugs (3) of entrance cover strip (2) must not be
damaged.
If necessary, lever out remaining clips (1) in floor panel.
If necessary, replace faulty clips (1).
Slide clips (1) into clip mountings of entrance cover strip (2).
RA Removing and installing/replacing front (inside) left or right entrance cover st
BMW AG - TIS
08.02.2013 14:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -