Century L4-151 2.5L (1989)
Fuel Pressure: Technical Service Bulletins
Fuel Pressure - Relief Procedures Revision
Bulletin:
91-6C-1A
Date:
June '91
Ref. No.:
91-136A-6C
Corp. Ref. No.:
136301R
SUBJECT:
SERVICE MANUAL UPDATE-SECTIONS 6A, 6C, 6E FUEL SYSTEMS - PRESSURE
RELIEF (REVISED PROCEDURES)
MODELS AFFECTED:
1989-91 SKYLARK MODELS
1989-91 CENTURY MODELS WITH 2.5L ENGINES (VIN CODE R)
This bulletin is revised to include 1989-91 Century models and replaces Service Bulletin 91-6C-1 which may be discarded.
SERVICE MANUAL UPDATE - SECTIONS 6A, 6C, 6E2 AND 6E3
CAUTION:
-
TO REDUCE THE RISK OF FIRE AND PERSONAL INJURY, RELIEVE THE FUEL SYSTEM PRESSURE BEFORE SERVICING FUEL
SYSTEM COMPONENTS.
-
AFTER RELIEVING SYSTEM PRESSURE, A SMALL AMOUNT OF FUEL MAY BE RELEASED WHEN SERVICING FUEL LINES OR
CONNECTIONS. TO REDUCE THE CHANCE OF PERSONAL INJURY, COVER FUEL LINE FITTINGS WITH A SHOP TOWEL
BEFORE DISCONNECTING, TO CATCH ANY FUEL THAT MAY LEAK OUT. PLACE THE TOWEL IN AN APPROVED CONTAINER
WHEN DISCONNECT IS COMPLETED.
FUEL PRESSURE RELIEF PROCEDURE:
1989-91 2.3L (VIN D) and 2.5L (VIN R AND U)
1.
Loosen fuel filler cap to relieve tank pressure (Do not tighten at this time).
2.
Raise vehicle.
3.
Disconnect fuel pump electrical connector.
4.
Lower vehicle.
5.
Start engine and run until fuel supply remaining in fuel pipes is consumed. Engage starter for 3.0 seconds to assure relief of any remaining
pressure.
6.
Raise vehicle.
7.
Connect fuel pump electrical connector.
8.
Lower vehicle.
9.
Disconnect negative battery terminal to avoid possible fuel discharge if an accidental attempt is made to start the engine.
3.3L (VIN N)
Tool required:
J 34730-1, Fuel Pressure Gage
1.
Disconnect negative battery terminal to avoid possible fuel discharge if an accidental attempt is made to start the engine.