Century V6-3.1L VIN J (2005)
12.3. Remove the locking strip (C) on the 2-pin connector (H2-9). Open the terminal housing with a screwdriver. Remove the secondary catch (E)
on the connector and remove the optic cables coming from the OnStar(R) control modules.
12.4. Loosen one of the optic cables remaining in H2-9 (F), connect it to the connector and fit the secondary catch (E). Connect the connector so
that the optic cables are opposite each other (G). Connect the terminal housing (D) and refit the locking strip (C).
Important:
The optic cable must not be bent with a radius less than 25 mm (1 in).