Century V6-3.1L VIN J (2005)
Rear Door Striker: Adjustments
Lock Striker Adjustment - Door (With Mini Wedge)
Lock Striker Adjustment - Door (With Mini Wedge)
Tools Required
J 39346-A Mini-Wedge Door Striker Aligner
Important: The door must be properly aligned before adjusting the striker.
1. Open the door.
2. Loosen the door striker screws just enough to allow movement of the door striker.
3. Install the special toolJ 39346-A Mini-Wedge Door Striker Aligner.
Important: Do not slam the door.
4. Close the door while holding the outside handle in the open position.
5. Open the door.
Notice: Refer toFastener Notice in Cautions and Notices.
6. Tighten the door lock striker screws.
Tighten the door striker screws to 25 Nm (18 lb ft).
7. Remove the special toolJ 39346-A Mini-Wedge Door Striker Aligner.
8. Close the door.