Century V6-3.1L VIN J (2005)
4. For the SUPERCHARGED emblem/nameplate install as shown.
5. For the GS emblem/nameplate install to the following dimensions:
*
Dimension (a) is 85.725 mm (3.375 in) from the bottom edge of the rear compartment lid to the bottom of the emblem/nameplate.
*
Dimension (b) is 31.750 mm (1.250 in) from the right edge of the rear compartment lid to the edge of the emblem/nameplate.
6. For the LS emblem/nameplate install as shown.
7. Heat the mounting surface to approximately 27-41°C (80-105°F) using theJ 25070 , if necessary.
8. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
Important: Do not touch the adhesive backing on the emblem/nameplate.
9. Remove the protective liner from the back of the emblem/nameplate.
10. Position the emblem/nameplate to the location marks and press the emblem/nameplate to the mounting surface.
11. Apply equal pressure along the emblem/nameplate in order to uniformly bond the item to the mounting surface.
12. Remove the protective tape from the mounting surface.