Century V6-3.1L VIN J (2005)
Power Mirror Motor: Procedures
MOTOR REPLACEMENT - POWER MIRROR
REMOVAL PROCEDURE
CAUTION: Refer to Eye Protection Caution in Service Precautions.
1. Remove the front door trim panel.
2. Remove the mirror from the front door.
3. Remove the mirror face.
4. Remove the mirror motor screws.
5. Remove the mirror motor electrical harness through the mirror housing.
6. Remove the mirror motor from the mirror housing.
INSTALLATION PROCEDURE
1. Route the mirror motor electrical harness through the mirror housing.
2. Position the mirror motor to the mirror housing.
3. Install the mirror motor screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 10 N.m (89 lb in).
4. Install the mirror to the front door.
5. Install the mirror face.
6. Install the front door trim panel.
7. Check the mirror for proper operation.