Century V6-3.1L VIN J (2005)
Air Door Actuator / Motor: Service and Repair
Air Temperature Actuator - Right
AIR TEMPERATURE ACTUATOR REPLACEMENT - RIGHT
REMOVAL PROCEDURE
1. Remove the right side instrument panel insulator.
2. Remove the instrument panel compartment.
3. Disconnect the electrical connector from the right air temperature actuator.
4. Remove the screws which secure the right air temperature actuator.
5. Remove the electric actuator.
INSTALLATION PROCEDURE
1. Position the right air temperature actuator, then align the slots in the electric actuator driver to the flats on the shaft.
2. Align the locating hole to the alignment on the HVAC module case.
3. Slide the actuator driver on to the shaft. The actuator driver should seat completely on the shaft and the mounting holes should be flush with the
mounting bolts on the HVAC module case.
4. Install the screws to the right air temperature actuator.
Tighten the screws to 1.5 N.m (13 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.