Century V6-3.1L VIN J (2005)
Air Door Actuator / Motor: Service and Repair
Mode Actuator
MODE ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left instrument panel insulator.
2. Remove the instrument panel knee bolster bracket.
3. Disconnect the vacuum line from the mode actuator.
4. Lift the lock tab up (1) to remove the actuator.
5. Remove the mode actuator off the slides of the HVAC module assembly.
6. Disconnect the actuator pushrod from the mode door lever and remove the actuator.
INSTALLATION PROCEDURE
1. Connect the actuator pushrod to the mode door lever.