Century V6-3.1L VIN J (2005)
Vacuum Controller: Service and Repair
HVAC Systems - Automatic
VACUUM CONTROL ASSEMBLY REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right side instrument panel insulator.
2. Disconnect the electrical connector from the vacuum control assembly.
3. Disconnect the vacuum harness connector from the vacuum control assembly.
4. Remove the mounting screws from the vacuum control assembly.
5. Remove the vacuum control assembly.
IMPORTANT: Pull the vacuum control assembly straight down to release the tab from the slot in the HVAC module case.
INSTALLATION PROCEDURE
1. Align the tab to the slot in the HVAC module case, then push up to seat the vacuum control assembly.
2. Install the mounting screws to the vacuum control assembly.
Tighten the screws to 1.5 N.m (13 lb in).