Century V6-3.1L VIN J (2005)
Backup Light Bulb: Service and Repair
TAIL LAMP ASSEMBLY AND /OR BACKUP, SIDEMARKER, STOP, TURN SIGNAL BULB REPLACEMENT
REMOVAL PROCEDURE
1. Open the rear compartment.
2. Remove the rear compartment convenience net, if equipped, from the plastic wingnut retainers.
3. Remove the visible plastic wingnut retaining the tail lamp.
4. Pull back the corner of the rear compartment trim panel to access the remaining plastic wingnuts.
5. Apply light pressure to the tail lamp lens to retain the lamp in position during removal of the remaining plastic wingnut retainers.
6. Remove the remaining plastic wingnuts retaining the tail lamp.
7. Remove the tail lamp assembly from the rear body panel and support the tail lamp assembly.
8. Rotate the lamp sockets counterclockwise to remove them from the tail lamp housing.
9. Remove the tail lamp housing assembly.
10. Remove the tail lamp bulbs from the sockets, if required.
INSTALLATION PROCEDURE
1. Install the tail lamp bulbs to the sockets, if removed.
2. Install the tail lamp sockets to the tail lamp housing, rotating clockwise until fully seated.