Century V6-3.1L VIN J (2005)
1. Install the EBCM to the BPMV.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the 4 retainers that attach the EBCM to BPMV.
Tighten the retainers to 5 Nm (44 inch lbs.).
3. Connect the EBCM harness connector.
4. Push down lock tab (1) and then move sliding connector cover (2) back in the home position to lock.
5. Reengage the red locking tab (1) to the connected lock tab.
6. Install the air cleaner intake duct.
7. Reposition the module and cables. Connect the cruise control module to the left strut tower.
8. Connect the accelerator and cruise control cable to the accelerator control cable bracket.
9. Install the front fender upper diagonal brace.
10. Turn the ignition switch to the RUN position, do not start engine.
11. Perform the Diagnostic System Check - Vehicle.
