Century V6-3.1L VIN J (2005)
IMPORTANT: Align the blower motor control processor forward retaining slots onto the screws and seat the blower motor control processor against
HVAC module.
2. Install the blower motor control processor rearward screw.
Tighten the screw to 1.5 N.m (13 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Tighten the blower motor control processor forward screws.
Tighten the screws to 1.5 N.m (13 lb in).
4. Connect the blower motor control processor electrical connector to the blower motor.
5. Connect the electrical connector from the blower motor control processor.
6. Install the right side IP insulator.