Century V6-3.1L VIN J (2005)
2. Install the SDM (2) horizontally to the vehicle (3).
3. Point the arrow on the SDM toward the front of the vehicle.
4. Install the SDM mounting fasteners (1).
Tighten the fasteners to 10 N.m (89 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
5. Connect the connector to the SDM.
6. Install the CPA to the SDM connector.
7. Position the carpet to cover the SDM.
8. Reposition the front and rear door weatherstrips as required.
9. Install the right side front and rear carpet retainers.
10. Install the center pillar, lower trim panel.
11. Install the right insulator panel.
12. Install the passenger front seat.
13. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9.
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set, requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
thoroughly to ensure that the SDM is set properly.
