Century V6-3100 3.1L VIN M SFI (1998)
10. Using the J 5239 pull the piston and rod assembly down to the crankshaft.
11. Remove the J 5239
12. Install the lower connecting rod bearing into the connecting rod cap.
13. Coat the inside surfaces of the lower connecting rod bearing with new engine oil.
14. Install the connecting rod cap.
15. Install the connecting rod cap nuts.
^
Tighten the connecting rod nuts to 20 Nm (15 ft. lbs.). Use the J 36660 in order to rotate the nuts an additional 75 degrees.
Notice: Refer to Fastener Notice in Service Precautions.
16. Inspect the connecting rod for a binding by prying back and forth with a suitable tool. If necessary, loosen and retighten the connecting rod cap.
17. Measure the connecting rod clearance using the following procedure:
17.1.Install all connecting rod bearings.
17.2.
Lightly tap each connecting rod parallel to the crankpin in order to make sure the connecting rods have clearance.
17.3.
Measure the side clearance between the connecting rod caps using a feeler gage, or dial indicator. Refer to Crankpin (Rod Side Clearance).
18. Install the crankshaft oil deflector.
19. Install the oil pump.
20. Install the oil pan.
21. Lower the vehicle.
22. Install the cylinder head(s).
