Century V6-3100 3.1L VIN M SFI (1998)
2. Install the engine mount upper nuts.
^
Tighten the engine mount upper nuts to 47 Nm (35 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Lower the vehicle.
4. Lower the engine.
5. Raise and suitably support the vehicle.
6. Install the engine mount bracket to the oil pan.
7. Install the engine mount bracket-to-oil pan bolts.
^
Tighten the engine mount bracket bolts to 58 Nm (43 ft. lbs.).
8. Install the right engine splash shield.
9. Install the right front wheel and tire.
10. Connect the three-way catalytic converter pipe to the right (rear) exhaust manifold.
11. Lower the vehicle.
12. Remove the J28467-B
13. Install the engine mount struts.
14. Install the throttle body air inlet duct.
15. Connect the battery ground (negative) cable.
