Century V6-3100 3.1L VIN M SFI (1998)
1. Position inlet hose to pump.
2. Inlet hose.
^
Tighten inlet hose fitting to 27 Nm (20 ft. lbs.).
3. Power steering pump pulley.
4. Drive belt.
5. Raise and suitably support vehicle.
6. Support frame using jack stands.
7. Remove rear frame bolts.
NOTICE: Do not lower rear frame too far as damage to engine components nearest to the cowl may result.
8. Rear frame mount bolts and lower rear of frame up to 128 mm (5 inches).
9. Inlet hose to steering gear.
^
Tighten inlet hose fitting to 27 Nm (20 ft. lbs.).
10. Power steering gear outlet hose clip.
11. Raise frame.
12. New rear frame bolts.
13. Position plastic cover and intermediate steering shaft lower bolt.
14. Lower vehicle.
15. Engine mount strut at engine.
16. Fill power steering pump reservoir with fluid.
17. Bleed system.
^
Inspect for leaks.
