Century V6-3100 3.1L VIN M SFI (1998)
3. Insert the J 34013-38 into the strut (1) in order to guide the strut shaft.
4. Start turning the compressor screw (3) clockwise on J 34013-B, while guiding J 34013-38 to the center strut shaft.
5. Continue to turn the compressor, forcing the screw on the strut compressor until the strut shaft threads are visible through the top of the strut.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
6. Attach the washer and the nut. Remove the J 34013-20 from the strut shaft.
Tighten
Tighten the strut mount nut to 85 Nm (63 ft. lbs.) with a 24 mm wrench (2) while holding the strut shaft with a 50 Torx(R) socket (3).
7. Remove the strut (1) from the strut compressor.
8. Install the strut to vehicle. Refer to STRUT REPLACEMENT.
