buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Heating and Air Conditioning > < Front Suspension
Page 1
background image

Wheel Fastener: Service and Repair
Rear Suspension

REMOVAL PROCEDURE

^

Tools Required:
-

J 6627-A Wheel Bolt Remover

1. Raise and support the vehicle. 
2. Remove the tire and wheel assembly. Refer to WHEEL REMOVAL in TIRES AND WHEELS.
3. Remove the brake caliper. Refer to BRAKE CALIPER REPLACEMENT (REAR) in DISC BRAKES.
4. Remove the rotor (3). Refer to BRAKE ROTOR REPLACEMENT (REAR) in DISC BRAKES.
5. Use the J 6627-A (2) to extract the wheel hub bolt from the hub (1).
6. Clean the wheel hub flange and clean the rotor of any corrosion, metal chips or foreign material.

INSTALLATION PROCEDURE

1. Install the replacement bolt in the wheel hub (1).
2. Add enough washers to draw the bolt into the hub.

Important:  Seat the wheel bolt fully against the hub flange.

NOTICE:  Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.

3. Install the wheel nut with the flat side to the washers. 

Tighten 
Tighten the wheel nut until the wheel bolt head seats against the hub flange.

4. Back off the wheel nut.
5. Remove the washers.
6. Install the rotor (3). Refer to BRAKE ROTOR REPLACEMENT (REAR) in DISC BRAKES.
7. Install the brake caliper. Refer to BRAKE CALIPER REPLACEMENT (REAR) in DISC BRAKES.
8. Install the tire and wheel assembly. Refer to WHEEL INSTALLATION in TIRES AND WHEELS. 
9. Lower the vehicle.

Heating and Air Conditioning > < Front Suspension