Century V6-3100 3.1L VIN M SFI (1998)
9. Remove the servo spring (49).
INSTALLATION PROCEDURE
IMPORTANT: Follow this procedure exactly or the transaxle will have no reverse gear due to the servo pin missing the band.
1. Jack up the driver side (channel plate side) of the car until it is higher than the differential side. This ensures that the reverse band is in the proper
location and not cocked to the channel plate side of the case.
2. Install the servo spring (49).
3. Install the servo assembly (42-48).
4. Install the reverse servo cover (40) with new O-ring seal (41).
5. Install the snap ring (39).
6. Install the throttle body air inlet duct. Refer to Throttle Body Assembly Replacement in Powertrain Management.
