Century V6-3100 3.1L VIN M SFI (1998)
Power Window Switch: Service and Repair
Rear Door - Sedan
POWER WINDOW SWITCH
Rear Door - Sedan
REMOVAL PROCEDURE
IMPORTANT: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of
shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.
IMPORTANT: Use a protective coating/tape at the point of insertion of the flat surface tool. Damage to the inner door panel may occur if it is not
protected.
1. When removing a power window switch (front or rear door), insert a plastic, flat bladed tool at the front edge of the switch mounting plate. Press
rearward to release the mounting plate retainer and lift up on the front of the plate.
2. Remove the switch from the bezel.
3. Remove the switch from the bezel.
4. Disconnect the electrical connector from the power window switch.
5. Remove the switch from the door.
INSTALLATION PROCEDURE
