Electra V6-260 4.3L DSL (1984)
Diesel MFI Pump: Service and Repair
Throttle Shaft Seal Replace
Fig. 15 Fuel filter & lines. V6 engine
V6 ENGINE
1.
Remove air crossover and install cover J-29657 or equivalent.
2.
Disconnect fuel return pipe, Fig. 15, then remove governor control cover screws and the cover.
3.
Remove fast idle solenoid and vacuum regulator valve.
4.
Disconnect throttle cable and TC detent cable.
5.
Disconnect throttle return spring.
6.
Install tool J-29601 or equivalent over throttle shaft with slots of tool engaging vacuum regulator valve lock pin. Place spring clip of tool over
throttle shaft advance cam and tighten wing nut. Without loosening wing nut, pull tool off of shaft.
Fig. 27 Throttle shaft & seals. V6 engine