Electra V8-307 5.0L (1982)
2.
Remove the staggered 3-way connector body from the power antenna wiring by releasing the secondary terminal locks and remove three (3)
terminals and wires from the connector.
3.
Install the above terminals into the four-way connector body, part no. 8917542 (furnished with the jumper harness) as follows:
Cavity A - Dk. Green Cavity B - Gray Cavity C - White Cavity D - Blank
Close the secondary lock latch and inspect for proper terminal engagement.
4.
Plug one end of the jumper harness into the new relay, part no. 10030273 (2 connectors). Plug the other end onto the IP harness and the converted
power antenna lead.
5.
Tape relay to IP harness in a horizontal or terminal down position so that it is rattle free..
6.
Check power antenna operation.
PARTS INFORMATION
The following part numbers are included in the power antenna relay kit, part number 22524833:
1 - Relay P/N 10030273 1 - Adapter Harness P/N 12038466 1 - Connector Body P/N 8917542
WARRANTY INFORMATION
Power antenna relay kits installed under warranty must be submitted using the following information.
Trouble
Operation
Labor
Failed P/N
Code
Number
Hours
22524833
92
R0620
0.3