buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Body - Maintaining Exterior Weatherstrip Appearance|Page 3058 > < Body - Maintaining Exterior Weatherstrip Appearance
Page 1
background image

Weatherstrip: Technical Service Bulletins
Rear Deck Lid Weatherstrip Ooze-Out - Replacements

Model Year:

1983

Bulletin No.:   

83-82

File in Group:

BODY

Number:

17

Date:

April, '83

SUBJECT:

Rear Compartment Weatherstrip Ooze-Out Service Replacements on all 1981-'83 Models - Except Skyhawks

A new sealer less deck lid weatherstrip (Part No. 20469449) has been released for service only and should be used when correcting conditions of deck
lid weatherstrip sealer ooze-out.

The new weatherstrip does not require sealer in the carrier. Only one length of the new weatherstrip will be serviced, therefore, replacement will include
a cut to fit operation.

Should it become necessary to replace a rear compartment lid weatherstrip the following procedure should be followed.

Replacement Procedure:

Rear Compartment Lid Weatherstrip

1.

Remove lid weatherstrip and clean all sealer from flange around entire lid opening.

2.

Begin inserting middle of weatherstrip onto gutter flange at the center of, the opening between hinges. Be sure weatherstrip is completely seated to
flange around entire opening.

3.

Cut off any extra material and cement butt ends together using 3M 8011 Black Weatherstrip Adhesive or equivalent.

4.

Close lid and water test complete lid area.

5.

Open lid check for leak areas.

6.

If leaks occur remove weatherstrip from flange:

a)

Brush 3M 8011 Black Weatherstrip Adhesive or equivalent on both sides of the flange completely around opening.

Body - Maintaining Exterior Weatherstrip Appearance|Page 3058 > < Body - Maintaining Exterior Weatherstrip Appearance