Enclave AWD V6-3.6L (2009)
A revised calibration has been developed to address this condition. Technicians are to reprogram the heated seat module using the Service Programming
System (SPS) with the latest software available on TIS2WEB. Refer to the Service Programming System (SPS) procedures in SI.
When using a Tech 2(R) or a Multiple Diagnostic Interface (MDI) for reprogramming, ensure that it is updated with the latest software version.
During programming, the battery voltage must be maintained within the proper range of 12-15 Volts. Only use the approved Midtronics(R) PSC 550
Battery Maintainer (SPS Programming Support Tool EL-49642) or equivalent during programming.
Warranty Information #2
For vehicles repaired under warranty, use the table.
Disclaimer
