Enclave AWD V6-3.6L (2009)
Wheel Fastener: Service and Repair
Front Suspension
Wheel Stud Replacement
Tools Required
J 35917 Ball Joint Remover
Removal Procedure
Warning
If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s) or the wheel bolt(s), install only new GM original equipment parts. Installation of
used parts or non-GM original equipment parts may cause the wheel to loosen, loss of tire air pressure, poor vehicle handling and loss of vehicle control
resulting in personal injury.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair).
3. Remove the brake rotor. Refer to Front Brake Rotor Replacement (See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Front Brake Rotor Replacement).
4. Use the J 35917 in order to press the wheel stud (1) from the bearing/hub (2).
Installation Procedure
1. Install a new wheel stud from the back side of the bearing/hub.
2. Install 3 flat washers (1) to the wheel stud (3).
3. Install a hex nut (2) to the wheel stud (3).
