LaCrosse V6-3.6L (2007)
Important: Care must be taken not to damage the solenoid valves when the EBCM is removed from the BPMV.
9. Separate the EBCM (1) from the BPMV (4) by gently pulling apart until separated.
10. Disconnect the pump motor connector (3) at the bottom of the EBCM.
Installation Procedure
1. Connect the pump motor connector (3) to the bottom of the EBCM.
2. Install the EBCM (1) to the BPMV (4).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the 6 EBCM to BPMV retaining bolt/screws (2).
Tighten the retaining bolt/screws to 2.9 N.m (26 lb in).
4. Connect the EBCM harness connector.
5. Reengage the locking tab (1) to the EBCM harness connector.
6. Install the air cleaner intake duct.
7. Install the front fender upper diagonal brace.
8. Install the fuel injector sight shield, 3.8L engine only.
9. Turn the ignition switch to the RUN position, do not start engine.
10. Perform the Diagnostic System Check - Vehicle. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check
- Vehicle
11. Refer to Control Module References for programming and setup information.