LaCrosse V6-3.6L VIN 7 (2006)
Separate the EBCM (1) from the BPMV (4) by gently pulling apart until separated.
10. Disconnect the pump motor connector (3) at the bottom of the EBCM.
Installation Procedure
1. Connect the pump motor connector (3) to the bottom of the EBCM.
2. Install the EBCM (1) to the BPMV (4).
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the 6 EBCM to BPMV retaining bolt/screws (2).
^
Tighten the retaining bolt/screws to 2.9 Nm (26 inch lbs.).
4. Connect the EBCM harness connector.
5. Reengage the locking tab (1) to the EBCM harness connector.
6. Install the air cleaner intake duct.
7. Install the front fender upper diagonal brace.
8. Install the fuel injector sight shield, 3.8L engine only.
9. Turn the ignition switch to the RUN position, do not start engine.
10. Perform the Diagnostic System Check - Vehicle. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures