LaCrosse V6-3.6L VIN 7 (2006)
9. Remove the wiring harness from the seat belt pretensioner through the seat bottom frame.
10. Remove the pretensioner from the seat.
INSTALLATION PROCEDURE
1. Position the pretensioner to the seat bottom frame.
2. Position the wiring harness to the seat belt pretensioner through the seat bottom frame.
3. Connect the pretensioner electrical connector to the seat electrical harness.
4. If equipped, connect the seat belt reminder cable.
5. Install the nut to the seat belt pretensioner.
Tighten the nut to 35 N.m (26 lb ft).
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the pretensioner electric connector (1) and position assurance pin (2) to the body harness.
7. Connect the seat harness connector to the body harness.
8. Install the driver seat bolts.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 or to SIR Disabling and Enabling Zone 9.
10. If the pretensioner is to be scrapped, deploy the pretentioner. Refer to Pretensioner Handling and Scrapping.
11. If the pretentioner is to be returned undeployed to the manufacturer for warranty, refer to Pretensioner Handling and Scrapping.