LaCrosse V6-3.8L (2009)
9. Remove the SDM mounting fasteners (1).
10. Remove the SDM (2) from the floor pan (3).
Installation Procedure
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Install the SDM (2) horizontally to the vehicle (3).
3. Point the arrow on the SDM toward the front of the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the SDM mounting fasteners (1).
Tighten the fasteners to 10 Nm (89 lb in).
5. Connect the connector to the SDM.