LaCrosse V8-5.3L (2008)
Keyless Entry Module: Service and Repair
Remote Control Door Lock Receiver Replacement
Removal Procedure
1. Remove the rear window shelf trim panel. Refer to Rear Window Shelf Trim Panel Replacement (See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Service and Repair).
2. Disengage the outboard receiver retainers from the rear shelf.
3. Lift the receiver from the rear window shelf trim panel and disconnect the electrical connector.
4. Remove the receiver.
Installation Procedure
1. Connect the electrical connector to the receiver.
2. Install the receiver by positioning the inboard retainer to the slot in the rear window shelf trim panel. Press the outboard retainers into the rear
window shelf trim panel openings.
3. Install the rear window shelf trim panel. Refer to Rear Window Shelf Trim Panel Replacement (See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Service and Repair).
4. If a new remote control door lock receiver is being installed, program the transmitters. Refer to Control Module References (See: Testing and
Inspection/Programming and Relearning) for programming and setup information.