LaCrosse V8-5.3L (2008)
11. Remove the lower windshield supports (1) from the cowl panel, if equipped.
Important: Keep the cutting edge of the tool against the window.
12. This will allow the urethane adhesive to be separated from the window.
*
Leave a base of urethane on the pinchweld flange.
*
The only suitable lubrication is clear water.
*
Use J 24402-A , J 39032 or equivalent in order to remove the window.
13. Remove the windshield (1) from the vehicle with the aid of an assistant (2).
Installation Procedure
1. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows (See: Windows/Window Glass/Service and
Repair).
2. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement (See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair).
3. Install the windshield wipers arms and blades. Refer to Windshield Wiper Arm Replacement (See: Wiper and Washer Systems/Wiper Arm/Service
and Repair).
4. Install the windshield garnish molding. Refer to Windshield Pillar Garnish Molding Replacement (See: Body and Frame/Interior Moulding /
Trim/Trim Panel/Service and Repair).
5. Install the rearview mirror. Refer to Inside Rearview Mirror Replacement (See: Body and Frame/Mirrors/Service and Repair/Inside Rearview
Mirror Replacement).
6. Connect the rain senor connector, if equipped.
7. Connect the diversity antenna, if equipped.
8. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
9. Close the hood.